Table of Contents
Advertisement
MOWER BELT REPLACEMENT
To avoid damaging belts, DO NOT
PRY BELTS OVER PULLEYS.
44" Decks:
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, lock the motion
control levers into their neutral locked positions, turn
off the engine, and remove the ignition key.
2. Remove the hardware (B, Figure 24) securing the
belt guards (A) to the mower deck, and remove the
guards.
3. Raise the mower deck to its highest cutting position.
4. Pull back firmly on the belt tensioning idler (E, Figure
23) in the direction indicated, and remove the belt
from the left arbor pulley (A).
5. Remove the old belt from the remaining pulleys.
6. Reversing steps 4 - 5, install the new belt, following
the routing in Figure 23. Be sure to replace the belt
guards.
FUSE REPLACEMENT
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, lock the motion
control levers into their neutral locked positions, turn
off the engine, and remove the ignition key.
2. Raise the seat. The fuse block is located on the right
side of the rear seat support.
3. Remove and check the suspected fuse (or fuses). If
blown, replace with a fuse with a rating equal to the
ratings indicated in Figure 25.
WARNING
Do not use a fuse with a rating other than that
specified. Serious equipment damage may result.
1/2006
D
B
Figure 23. Mower Belt Routing - 44" Decks
A. Right Arbor Pulley
B. Left / Center Arbor Pulley
C. PTO Pulley
D. Stationary Idler
E. Belt Tensioning Idler
A
Figure 24. Belt Guard Removal
A. Belt Guard (Left side shown, right side similar)
B. Securing Hardware
A
B
C
D
Figure 25. Fuse Designations and Ratings
A. Start - 15 Amp
B. PTO - 7.5 Amp
C. Charge - 30 Amp
D. Accessory - 30 Amp
19
250 Z & Javelin Series
C
E
B
TP 300-5148-00-HZ-SN
A
Advertisement
Table of Contents
