Wall Mount Option; Downloading Procedure For Srp-350 Wall Mount Printer Software - Samsung SRP-350 Integrator's Manual

Wall Mount Option

Downloading Procedure for SRP-350 Wall Mount
Printer Software
This special software version is for use when wall-mounting the SRP-350 printer.
The Paper near end sensor has been disabled in this special version.
Note: Part Number for Wall Mount Bracket is 101218.
1. Turn off the printer.
2. Set the SW2 DIP switch 2-3 to ON position.
3. Connect the printer to PC with a standard Parallel printer cable. If using a
serial connection use the cable described below.
4. Open the printer cover.
5. Press the paper feed key and turn on the printer while holding down the feed
key.
6. Execute the 350loade.exe. You must input the number for type of interface,
3 for parallel (lpt1) downloading.
7. Enter the binary file name you want to download. Example: 350_wall.bin.
8. You should see download status scroll on your PC screen.
9. Download complete.
10. Turn off printer and set SW2 DIP switch 2-3 to OFF position.
11. Turn on printer and check version and operation.
PC Printer
DB-9F DB-25M
DCD 1 1
RXD 2 2
TXD 3 3
DTR 4 4
GND 5 5
DSR 6 6
RTS 7 7
CTS 8 8
VCC 9 20
22
16 • Wall Mount Option
NC
TXD
RXD
RTS
CTS
DSR
GND
CD
DTR
Serial Printer Cable
CRS Part No. 250030
Samsung SRP-350 Setup & Service Information