Changing The Frame Control Paper Position; Installing Wall Mount - Samsung SRP-275 Operator's Manual

CHAPTER 1
Setting up the printer

1.7 Changing the frame control paper position

1-6
1) Open the rear cover.
2) Remove the frame control paper by loosing
the two screws(3 x 6).(76 mm default)
3) Reattach the frame control paper in you want.
(Insert and tighten two screws(3 x 6) to reattach.)
4) Close the rear cover.
5) Change the Memory Switch setting for changing
paper roll width. (See the instuctions "Setting the
Memory Switches"(3.1) in Chapter 3.)
1.8 Installing wall mount (Option)
1) Turn the Set over and attach the Bracket hanger
2) Attach the Bracket mount to tne wall firmly with
3) Insert the Bracket hanger of Set to the Bracket
to the Frame base then tighten four screws.
the eight screws. Be sure that the Bracket
attached properly to match the direction of arrow
as shown. And the Bracket mount should be
always fixed vertically.
mount as shown.
1-7