Inappropriate Places For Installation - Marantz SM-11S1 User Manual

~ - h - ; s B - s - e ~ - t i - o F - n - ~ - u s - t - ~ - e - ~ - a - d U - b - e ~ - o r - e l _ ~ - n Y - ~ - o - n - n e - c - t i o - n - i - S - m-ad-e-t-o-------------------~}
I
the mains supply.
o
'0
'0
[
EQUIPMENT MAINS WORKING ]
~S_E_TT_IN_G ~
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your area.
Power requirements (U.S.A.) AC 120V 60Hz
- Power requirements (Europe) AC 230V SO/60Hz
0.2 m (8 ins.) or more
';=:L==""F=;===::!::::=====r""F==~0~.2
m (8 ins.)
or more
0.2 m (8 ins.) or more
( COPYRIGHT
)
Recording and playback of any material may require consent.
For further information refer to the following:
Copyright Act 1956
- Dramatic and Musical Performers Act 1958
- Performers Protection Acts 1963 and 1972
- Any subsequent statutory enactments and orders
INAPPROPRIATE PLACES FOR
INSTALLATION
To keep your player in perfect working orderfor the longest possible
time, avoid installing the player in the following locations.
Wherever it will be exposed to direct sunlight
Wherever it will be close to a heater or other heat-radiating
appliance
Wherever the humidity is high or ventilation is poor
Wherever it is very dusty
Wherever it will be subject to vibration
On top of a rickety stand or in an unstable location which is
tilted at an angle
In an audio rack with little space at the top and bottom or other
location where the heat dissipation will be obstructed
To ensure proper heat dissipation, install the player while
leaving clearances between the player and wall or other
components, as shown in the figure below.
• Do not place objects on top
• Refrain from placing any objects on top of the player.
• Cautions on handling power cord
• Do not touch the power cord with wet hands.
• When disconnecting the power cord, always make sure that
you take hold of the plug. Yanking out or bending the cord
can damage it and/or cause electric shocks or a fire.
• Get into the habit of disconnecting the power plug before
leaving home.
• Do not touch hot spots during and
Immediately After Use
During and immediately after use, the unit is hot in areas other
than the controls and rear panel connection jacks. Do not touch
hot spots and especially the top panel. Contact with hot areas
can cause burns.
3
~ - h - ; s B - s - e ~ - t i - o F - n - ~ - u s - t - ~ - e - ~ - a - d U - b - e ~ - o r - e l _ ~ - n Y - ~ - o - n - n e - c - t i o - n - i - S - m-ad-e-t-o-------------------~}
I
the mains supply.
o
'0
'0
[
EQUIPMENT MAINS WORKING ]
~S_E_TT_IN_G ~
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your area.
Power requirements (U.S.A.) AC 120V 60Hz
- Power requirements (Europe) AC 230V SO/60Hz
0.2 m (8 ins.) or more
';=:L==""F=;===::!::::=====r""F==~0~.2
m (8 ins.)
or more
0.2 m (8 ins.) or more
( COPYRIGHT
)
Recording and playback of any material may require consent.
For further information refer to the following:
Copyright Act 1956
- Dramatic and Musical Performers Act 1958
- Performers Protection Acts 1963 and 1972
- Any subsequent statutory enactments and orders
INAPPROPRIATE PLACES FOR
INSTALLATION
To keep your player in perfect working orderfor the longest possible
time, avoid installing the player in the following locations.
Wherever it will be exposed to direct sunlight
Wherever it will be close to a heater or other heat-radiating
appliance
Wherever the humidity is high or ventilation is poor
Wherever it is very dusty
Wherever it will be subject to vibration
On top of a rickety stand or in an unstable location which is
tilted at an angle
In an audio rack with little space at the top and bottom or other
location where the heat dissipation will be obstructed
To ensure proper heat dissipation, install the player while
leaving clearances between the player and wall or other
components, as shown in the figure below.
• Do not place objects on top
• Refrain from placing any objects on top of the player.
• Cautions on handling power cord
• Do not touch the power cord with wet hands.
• When disconnecting the power cord, always make sure that
you take hold of the plug. Yanking out or bending the cord
can damage it and/or cause electric shocks or a fire.
• Get into the habit of disconnecting the power plug before
leaving home.
• Do not touch hot spots during and
Immediately After Use
During and immediately after use, the unit is hot in areas other
than the controls and rear panel connection jacks. Do not touch
hot spots and especially the top panel. Contact with hot areas
can cause burns.
3