For more details about the NEDAP TRANSIT reader refer to the TRANSIT installation guide. The combined vehicle and driver ID is a unique NEDAP patented feature. Optionally the vehicle-ID can be sacrificed if more information from the personal ID card is required.
Booster may not be designed to withstand such temperatures and could suffer damage as a result. Nedap advises to remove the personal identification card when not in use. CAUTION: DO NOT LEAVE CARD IN ACCESS DEVICE WHEN LEAVING THE VEHICLE, AS THIS PRESENTS A SECURITY RISK.
( ♪ ♪ ♪ ) to indicate that the configuration settings have been accepted. 3.2 HOW TO CREATE A CONFIGURATION CARD NEDAP has developed a software application that allows system integrators to create configuration cards. This software can be downloaded from our website www.nedapavi.com.
Please note that when reading low-frequency cards with a Transition-Booster this setting is not used. For NEDAP and EM cards the extended-length is not required and therefore the Booster will automatically use standard-length (even if extended-length is selected in the configuration).
Page 8
The low frequency settings are only applicable for the Transition-Booster. Enable NEDAP PM Enable or disable the reading of NEDAP PM transponders. NEDAP PM cards are always transmitted to the TRANSIT reading using standard-length. See chapter 3.2.2.2. Enable EM4102 or compatible Enable or disable the reading of EM4102 and compatible transponders.
1 is not explained, but can be shown by the configuration software by clicking ‘Show configuration details’ in the ‘Expert’ menu. Configuration Data Sector 0 is reserved for MAD (Mifare Application Directory). If the MAD is programmed, the Nedap configuration segment should have application id 517F. 3.3.2.1 COPY TO CLIPBOARD Copy the configuration data to clipboard by clicking ‘Copy to clipboard’...
5. Place the cover on the housing and tighten the four screws back in place. The Prox-Booster contains a non-rechargeable lithium battery which is soldered in place. The average lifetime of this type of battery is approximately 5 years. When replacement becomes necessary, contact Nedap about the battery replacement program.