Charging The Battery - Siemens SXG75 User Manual

of SXG75, FUG us-en, A31008-H8900-A1-1-7619 (07.10.2005, 13:11)
right page (17)
Inserting/removing the
RS MultiMediaCard
Please observe the manufacturer's
operating instructions that come
with the RS MultiMediaCard.
Attention
Before removing the RS MultiMediaCard,
carry out the
tings menu (page 127). This prevents any
possible data loss.
• Press on the tray. The tray for the
card is opened. You can remove
the tray.
• Insert the card on the tray (ensure
that the chamfered corner is in the
correct position 1). Insert the tray
with the card into the phone 2
until it snaps in.
Eject card function in the set-
Getting started

Charging the battery

The battery is not fully charged
when delivered. Plug the charger
cable into the bottom of the phone,
plug the power supply unit into a
mains power socket and charge for
at least two hours.
Only use the plug-in power supply
included in delivery!
As an alternative, the battery can
be charged via the USB port
(Accessories, page 137).
Y
Display during charging.
Charging time
An empty battery is fully charged af-
ter about 2 hours. Charging is only
possible within a temperature range
of +5 °C to 45 °C (41 °F to 113 °F). If
the temperature rises/falls 5 °C (9 °F)
above/below this, the charge symbol
flashes a warning. The mains voltage
specified on the power supply unit
must not be exceeded.
The charge level of the battery is
only displayed correctly after an un-
interrupted charging/discharging
cycle. You should therfore not remove
the battery unnecessarily and where
17