Acoustic; Power Supply, Battery And Charging - Siemens A70 Service Repair Documentation

Hide thumbs Also See for A70:
Table of Contents

Advertisement

s Com
Company Confidential
Copyright 2005© Siemens AG

8 Acoustic

he speaker module is designed to provide good performance for mobile handsfree and
T
sound ringer. The speaker module is a system which has a closed front volume with sound-
outlets towards the ear of the user. The speaker is partly hidden behind the display to save
length of the phone. The back volume of speaker module is using the unused air between the
antenna and the PCB. The speaker module is connected to the SAR-frame and contacted via
two bending springs to the PCB. For avoiding any interference between antenna and
earpiece, there is an antenna reference plate soldered behind the speaker at the PCB. In
ringer mode acoustic shock is avoided by using ramping of the ringer level.
The microphone is built in the Mounting Frame Lower Part and is mechanically fixed with a
rubber seal (gasket). The contact on the PCB is realised via spiral springs, which are
integrated in the gasket. Because of usage of Unidirectional Microphone, the gasket has a
front- and a back sound-inlet hole. The front sound-inlet is acoustically tighten connected with
a sound-inlet at the rear-side of the mounting frame lower part. The back sound-inlet is
acoustically tighten connected with a sound-inlet at the bottom-side of the mounting frame
lower part. The gasket of the microphone has a asymmetrical shape in order to provide non-
rotating, guaranteed covering of the sound-inlets of mounting frame lower part to the
corresponding sound-inlets at microphone gasket.
The buzzer and the keypad clicks will be realized over the earpiece.
The standard sounds will be generated by the EGOLDlite, the advanced sounds will be
generated via firmware running on the DSP.

9 Power Supply, Battery and Charging

All the important functions for the power supply of the phone are carried out by the power
supply ASIC.
The POWER-pin of the I/O-Connector is for charging the battery with an external power
supply.
Page
of
34
53
TD_Repair_L2.5_A70_A75_R1.0.pdf
Release 1.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

A75

Table of Contents