Seat And Safety Switch Assembly - Snapper 355Z Operator's Manual

Seat & Safety Switch Assembly
1. Pivot the ground speed / steering control levers out to
the NEUTRAL position and pivot the seat plate (B, Figure
5) forward.
2. Mount the seat (A) to the seat plate (B) using four 5/16-
18 nylock flange nuts (C) and tighten securely.
3. Press the seat switch wire harness end (D) onto the seat
switch until the latch of the seat switch wire harness end
snaps down over the lock on the seat switch.
Seat Adjustment
The seat and ground speed control levers should be adjusted
so that operator's elbows are supported by the arm rests
when his/her hands are on the controls, and the ground
speed control levers can be moved through their full range of
motion without contacting the operator's legs.
Seat Position Adjustment
The seat can be adjusted forward and back. Move the
adjustment lever (A, Figure 6) towards the left hand side of
the machine, slide the seat to the desired position, and
release the lever.
B
C
Figure 5. Seat Installation
A. Seat
B. Seat Plate
C. 5/16-18 Nylock Flange Nut (4)
D. Seat Switch Wire Harness
Figure 6. Seat Adjustment
A. Adjustment Lever
A
D
C
A
13