Using The Channel / Buttons To Sequentially Change Channels; Using The Channel Return Button To Return To The Previous Viewed Channel; Selecting A Picture Mode; Using The Freeze Function - BenQ DV3750 User Manual

channel 28, press the Channel entry button, and then the
buttons on the remote control.
Using the Channel
Press the Channel
Channel buttons on the display to sequentially select the TV channels available in your area.

Using the channel return button to return to the previous viewed channel

To return to the previous viewed channel, press the
control.

Selecting a Picture Mode

To select a picture mode, press the
enables you to select from the 6 preset memory settings. (Vivid, Standard, Movie, Sports,
Personal 1 and Personal 2)

Using the Freeze Function

Press the /
Press the /

Adjusting Aspect Ratio

Press the /
ratio you prefer.
Press the button several times to cycle through various ratios.
Full Screen - Enlarge the standard 4:3 video signal (e.g. TV signal) to 16:9 full
screen video signal. When the original input video source is 16:9 in ratio (e.g.
•
DVD signal), no change will occur.
4:3 - Display the standard 4:3 video signal (e.g. TV signal) in the center of the
screen at the ratio of 4:3. The screen does not change, but black blocks appears
•
in the left and right sides of the screen. When the input video source is 16:9 in
ratio, deformation will occur on the screen.
Letterbox -Fill the entire 4:3 screen with a 4:3 video signal. The redundant part
on the upper and bottom of the image will be removed and the image will
•
extend vertically and horizontally to fill the full screen. When the input video
source is 16:9 in ratio (e.g. DVD signal), no change will occur.
Anamorphic - Fill the entire screen with a 4:3 video signal. Some deformations
may be identified on the edge of the image. When the input video source is 16:9
•
in ratio (e.g. DVD signal), no change will occur.
Real - Display the actual size of the video source without zooming.
•

Using the Picture-in-Picture (PIP)/Picture-by-Picture (PBP) Function

If your display is connected to an additional Video or PC source, pressing the
ton allows you to display both images on the screen at once in PIP (Picture In Picture) or PBP
(Picture By Picture) modes:
• Full Screen: Normal display.
16 Using the Remote Control
/ buttons to sequentially change channels
or Channel buttons on your remote control, or press the Channel
(Picture mode) button on the remote control. This
(Freeze) button on the remote control to freeze the image on the screen.
(Freeze) button again to restore normal motion.
(Screen aspect ratio) button on your remote control to select the image aspect
, channel selection
(Channel return) button on your remote
or
PIP/PBP but-