Appendix F: Assigning Stagebox Patch To Existing Scenes - Yamaha SB168-ES Quick Setup Manual

Appendix F: Assigning stagebox patch to existing SCENEs

If you are an experienced LS9 user and you have pre-existing SCENEs saved in your console
or on a USB stick, you will find that loading these sessions and recalling these SCENEs will
recall the patching that was used when they were created. If the SCENEs were created
before the addition of SB168-ES, then they will not suit your new SB168-ES remote stagebox
system.
This appendix explains a method using the "Focus" feature to change the patch information in
existing SCENEs.
This section shows a short-cut method to insert one SCENE into another session without using
Studio Manager. Alternatively, if you prefer, you can do this with Studio Manager by dragging the
SCENE from a second open instance of LS9 Editor.
Backup
Load Your
file.L9A
Appendix
1. Backup your console session to a USB key.
2. Make a note of HA values as these are not copied
1. -15dB
from AD IN to SB168 HA.
2. +10dB
3. +5dB
4. -21dB
5. -26dB
6. -19dB
7. 0dB
8. +3dB
3. Load up the Pre-patched SB168-ES.L9A session.
4. In the SCENE page, copy the SB168-ES SCENE to
the Copy buffer (As if you were going to copy and paste a
SCENE).
14