Rehingeing The Door - AEG SANTO 70398-28 DT Operating Instructions Manual

Rehingeing the door

The door opening can be reversed if
required.
Warning! When reversing the door
the appliance may not be connected
to the mains. Remove plug from the
mains beforehand.
Procced as follows:
1. Remove the upper hinge by
unscrewing the fixing screws taking
care for the upper door not to fall
off.
Remove the upper door.
2. Remove the upper cover by
unscrewing the fixing screws and fix
it in the opposite side.
3. Remove the middle hinge by
unscrewing the fixing screws.
Remove the lower door.
4. Unscrew the plastic plugs on the
middle crossbeam and screw them in
the opposite side.
5. Pull off the plinth by unscrewing the
fixing screws.
6. Remove the lower hinge by
unscrewing the fixing screws.
7. Using a 12mm spanner, unscrew the
hinge pin and reassemble it in the
opposite side of the hinge.
8. Remove the leveling foot placed
below the side of the appliance and
screw it in the opposite side.
9. Fix the lower hinge on the opposite
side using the screws previously
removed. Slide the cover out of the
plinth by pushing it in the direction
of the arrow and reassemble it in the
opposite side.
10. Fix the plinth using the screws pre-
viously removed.
11. Reassemble the lower door.
12. Fix the middle hinge in the
opposite side using the screws
previously removed.
26
H