Starting The Hybrid Ip-Pbx - Panasonic KX-TDA100 Getting Started

2.7 Frame Earth Connection
IMPORTANT!
Connect the frame of the Hybrid IP-PBX to earth.
1.
Loosen the screw.
2.
Insert an earthing wire (user-supplied)*.
3.
Tighten the screw.
4.
Connect the earthing wire to earth.
* For earthing wire, green-and-yellow
insulation is required, and the cross-
sectional area of the conductor must be
more than 0.75 mm
• Proper earthing (connection to earth) is very important to protect the Hybrid IP-PBX from
the bad effects of external noise or to reduce the risk to the user of electrocution in the case
of lightning strikes.
• The earth wire of the AC cable has an effect against the external noise and lightning strikes,
but it may not be enough to protect the Hybrid IP-PBX. A permanent connection between
earth and the earth terminal of the Hybrid IP-PBX must be made.
3

Starting the Hybrid IP-PBX

CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the MPR Card before
start up.
• Before touching the System Clear Switch and the Reset Button, discharge static by
touching ground or wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not
perform the following procedures to start the Hybrid IP-PBX again. Otherwise, your
programmed data will be cleared.
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device, ensure that the
socket-outlet is located/installed near the equipment and is easily accessible.
1.
Set the System Clear Switch to the "SYSTEM INITIALIZE" position.
Power
Supply Unit
To AC
Outlet
10 Getting Started
or 18 AWG.
2
RUN Indicator
Screw
Earthing
wire
To earth
Reset Button
RESET
SYSTEM
INITIALIZE
NORMAL
System Clear Switch