Table of Contents
Advertisement
ThinkSystem 1610-4P NVMe Switch Adapter Installation and User Guide
February 28, 2018
Figure 2 Removing the Screws
3.
Keep the board on a level surface to make sure you do not lose any retaining clips. The heat sink is held in
place by the same screws that attach the bracket. The black retaining clips shown in the following figure can come
loose when the screws are removed.
Figure 3 Heat Sink Held in Place by Retaining Clips Attached by Bracket Screws
4.
Place the adapter on top of the replacement bracket. Make sure to position the bracket so that the screw holes
in the tabs are aligned with the openings in the board as shown in the following figure.
3_03572
CAUTION
Do not move or rock the heat sink after you remove the bracket
screws. Doing so might damage the thermal interface material, which
causes the board to overheat during operation. Damage to the heat
sink or the interface material while changing the bracket might void
the board warranty.
3_03569
- 6 -
Chapter 1: Hardware Installation
Replacing the Bracket
Advertisement
Table of Contents
