Water Drainage 127 - AEG LAVAMAT 1050 VI Operating Instructions Manual

Every appliance is fitted with a pump for discharging the wash and Water drainage
rinse water. This pump is controlled by the programme selector
mechanism and is capable of pumping water through the drain
hose to a height of up to 1 m above the surface on which the
machine is standing.
The curved end of the drain hose can be positioned in two ways:
Hooked over the edge of the sink. In view of the speed with
which the water comes out during the discharge phase, it is impor-
tant to ensure that the curved end of the hose cannot slip off the
edge of the sink. It should therefore be tied to the tap with a piece
of string or secured to the wall with a hook, by inserting the hook
into the hole provided in the curved part of the hose.
P0235
Joined into a branch of the sink waste pipe. The branch must
be above the sink trap and at least 60 cm above the floor.
The drain hose may be extended up to a maximum length of
400 cm. Use an extension with an internal diameter the same as
that of the original hose. Use a suitable connector.
The hose extension must rest on the floor and only the part near
the drainage point must be raised.
127