Engine Oil Dipstick; Engine Oil Check - Ford Edge 2016 Owner's Manual

ENGINE OIL DIPSTICK

A
E205005
A Minimum.
B Maximum.

ENGINE OIL CHECK

WARNINGS
Do not add engine oil when the
engine is hot. Hot engine oil can burn
you badly.
Do not remove the filler cap when
the engine is running.
To check the engine oil level do the
following:
1. Make sure that your vehicle is on level
ground.
2. Check the oil level before starting the
engine, or switch the engine off and
wait 15 minutes for the oil to drain into
the oil pan.
3. Remove the dipstick and wipe it with
a clean, lint-free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the oil level is at the minimum mark, add
oil immediately.
Note: Make sure that the oil level is
between the minimum and the maximum
marks.
Edge (CDQ, CWB) Vehicles Built From: 07-12-2015, GT4J 19A321 AKA enGBR, First Printing
Maintenance
B
Note: The oil consumption of new engines
reaches its normal level after approximately
5,000 km (3,000 mi).
Adding Engine Oil
Do not use supplemental engine oil
additives because they are unnecessary
and could lead to engine damage that may
not be covered by the vehicle Warranty.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Soak up any spillage with an
absorbent cloth immediately.
To top up the engine oil level do the
following:
1. Remove the engine oil filler cap. Turn
it counterclockwise and remove it.
2. Add engine oil that meets Ford
specifications. See Capacities and
Specifications (page 273).
E213396
242