Care Of Your Portable Steam Pocket - Shark PRO PORTABLE STEAM POCKET Owner's Manual

Using Your Portable Steam Pocket
with Flat Scrubber
Cleaning Tip: The Flat Scrubber is designed for cleaning a variety of surfaces and is
exceptional on those that are large and flat including counter tops, table tops, walls
mirrors, windows, stairs, shelves and other similar surfaces. Super absorbent micro-
fiber loosens, lifts, and locks in dirt and grime while sanitizing• at the same time.
fig. 8
1
To attach the All-Purpose Scrubber
pad, place the pad exterior side down
on a flat surface (lavender tab indicates
bottom of the pad) and insert the
top of the flat scrubber tool into the
top portion of the pad and then pull
each side over the back edges.
2
Press the Flat Scrubber Tool onto the
Accessory hose until it clicks into place
(fig. 8)
3 Press and hold the steam trigger
to create steam. While the steam
trigger button is pressed and held
down, the Power Light will be solid
blue. When released, the Power Light
will return to flashing blue. (fig. 9).
6 TOLL FREE: 1-800-798-7398
®
fig. 10
fig. 9
4 To remove the Flat Scrubber Tool,
press and hold down the release
button. Then slide the Flat Scrubber
off of the hose. (fig. 10)
CAUTION: Do not press steam
trigger while attaching or removing
the Flat Scrubber Tool.
CAUTION: Do not use the Flat
.
Scrubber without All-purpose
cleaning pad attached.

Care of Your Portable Steam Pocket

AFTER USE AND STORAGE
1
If you are also done cleaning, unplug
the cord from the outlet and place the
Handheld Scrubber on a flat surface.
Let the unit cool for 2-3 minutes.
2 Empty the water tank before
storage. Remove the water tank cap
and empty the tank over a sink.
Replace the water cap. (fig. 11)
fig.12
CARE OF YOUR MICRO-FIBER
CLEANING PAD
1 We recommend washing your
micro-fiber cleaning pad separately
from other fabrics to avoid picking
up lint. Only use liquid detergent
(no powder detergent). Don't use
any fabric softeners or bleach. Line
dry or dry on a low dryer setting.
(fig. 12)
2 If there are loose threads on the
micro-fiber cleaning pad carefully
cut the thread with scissors. Don't
pull on them or cut at the base.
IMPORTANT: The micro-fiber
cleaning pad may be very hot
from the steam. Use caution when
removing. Let the unit cool for 2-3
minutes.
®
fig. 11
fig.13
CLEANING THE NOZZLE
1 Your Portable Steam Pocket ® should
not normally require cleaning,
however, should you notice a
decrease in the steam output, it may
be necessary to remove mineral
deposits built up around the nozzles.
2 Unplug the cleaner from the
electrical outlet.
3 Use the provided nozzle cleaner or a
small diameter stiff metal wire, such
as a straightened metal paperclip,
and carefully insert the end of the
wire into the nozzle orifice. See
illustration above. (fig. 13)
4
Move the wire back and forth several
times to remove any deposits.
5
Plug in the appliance to the power
outlet and test steam output.
www.sharkclean.com
English
7