Stainless Steel Frame/Control Panel; Control Knobs; Stainless Steel Trough - Miele CS 1013-1 Operating And Installation Instructions

Stainless steel frame/control
panel
 Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and
stainless steel cleaning agent. We
recommend also using a stainless steel
conditioning agent to help prevent
resoiling (see "Optional accessories).
Do not use ceramic and stainless
steel cleaner or stainless steel
conditioning agent on the printing.
This would rub the printing off.
These areas should be only cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.

Control knobs

 Clean the control(s) with a solution of
warm water and a little washing-up
liquid applied with a soft sponge.
Stubborn soiling should be soaked
first.
 Dry the control(s) with a clean cloth.
Cleaning and care

Stainless steel trough

Do not clean the area between the
hob and the worktop with sharp,
pointed objects.
This could damage the seals.
Soiling, particularly salty food or
liquid and olive oil, can cause
damage if left on the printed surfaces
for a long time.
Remove any soiling which comes
into contact with the printed symbols
straight away.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
 Clean stainless steel surfaces with a
solution of warm water and a small
amount of washing-up liquid applied
with a soft sponge. In the case of
stubborn dried-on soiling, soak first.
If necessary, the rough side of non-
scouring sponge can be used.
 Finally, dry with a clean soft cloth.
Tip: The Miele conditioning agent for
stainless steel can be used after
cleaning to help keep your appliance
looking good (see "Optional
accessories"). Apply sparingly with a
soft cloth following the instructions on
the packaging.
25