Warranty; Know Your Unit; Assembly Instructions - Craftsman INCREDI.PULL 316.792021 Operator's Manual

4-cycle gas trimmer
Hide thumbs Also See for INCREDI.PULL 316.792021:
Table of Contents

Advertisement

Available languages

Available languages

If this Craftsman Professional product fails due to a defect in material or workmanship within three years from the date of purchase, return it to any Sears store,
Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only one year if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
As a trimmer:
Cutting grass and light weeds.
Edging
Decorative trimming around trees, fences, etc.
Rapid Rewind
®
Cutting
Head
INSTALL AND ADJUST THE D-HANDLE
1.
Place D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Place
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
2.
Start screws with a large
Flat-head or T-25 Torx
screwdriver. Do not tighten
until making the necessary
handle adjustment.
3.
While holding the unit in the
operating position (Fig. 13),
move the D-handle to the
location that provides the best grip.
WARRANTY STATEMENT
CRAFTSMAN PROFESSIONAL FULL WARRANTY
Throttle Lockout
Shaft Housing
Cutting Head
Shield
Line Cutting

ASSEMBLY INSTRUCTIONS

Shaft Grip
Screws (4)
Minimum 6 in.
(15.24 cm)
Bottom
Clamp
Fig. 1

KNOW YOUR UNIT

On/Off Control
D-Handle
Optional Hassle Free
®
PLUS
Cutting Head
Blade
4.
Tighten the clamp screws evenly, until the D-handle is secure.
INSTALL THE SHOULDER SUPPORT
1.
Put the shoulder support on
using the clip. (Fig. 2).
2.
Adjust by lifting slightly on
the rear of the lower clip then
push or pull the loose end of
the strap length to fit the
operator's size and comfort.
D-Handle
(Fig. 3).
3.
Attach the shoulder clip to
the unit. (Fig. 4)
4
Shaft Grip
Throttle
Control
Shoulder
Strap Loop
Choke Lever
Air Filter
Cover
Starter Rope
Grip
Fuel Cap
Primer Bulb
Muffler
Electric Start
Adapter
Fig. 2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents