Cleaning Mode - Panasonic KV-S1058Y Operating Manual

10.2.4 Cleaning Mode

Cleaning Mode can be used to help clean the conveyor rollers and the exit rollers. During Cleaning Mode,
the conveyor rollers and the exit rollers rotate a small amount every time the Start/Stop button (
the scanner is pressed. So you do not have to rotate the conveyor rollers and the exit rollers by using your
fingers in order to clean the entire surface of each roller.
Notice
•
Do not touch the rollers while they are rotating.
•
Use Cleaning Mode only to clean the conveyor rollers and exit rollers.
1.
Close the ADF door (page 32).
2.
Plug in the power cord.
3.
Turn ON the unit's power (page 31).
4.
Press and hold the Skip/Menu button (
5.
Use or of the cursor button to select "Maintenance".
6.
Press the OK button to complete your selection.
7.
Use or of the cursor button to select "Cleaning Mode".
8.
Press the OK button to complete your selection.
•
Cleaning Mode will start.
9.
Open the ADF door (page 32).
10.
Clean the conveyor rollers ( ) and exit rollers ( ).
i.
Use the Roller Cleaning Paper (page 13) to wipe the rollers from one end to the other (in the
direction of the arrow) all the way around them, as shown in the illustration.
ii.
Press the Start/Stop button (
iii.
Repeat these steps until all surfaces of all rollers are cleaned.
1
11.
Close the ADF door (page 32).
12.
Press the Skip/Menu button (
) for 1 second or more.
) on the scanner to rotate the rollers a small amount.
2
) to exit Cleaning Mode.
10.2.4 Cleaning Mode
) on
91