General Procedure; Unpacking The Device - Siemens RUGGEDCOM RSG907R Installation Manual

Chapter 2
Installing the Device
Section 2.1

General Procedure

The general procedure for installing the device is as follows:
IMPORTANT!
The user is responsible for the operating environment of the device, including maintaining the integrity
of all protective conductor connections and checking equipment ratings. Make sure to review all
operating and installation instructions before commissioning or performing maintenance on the
device.
Review the relevant certification information for any regulatory requirements.
1.
For more information, refer to
2. Unpack and inspect the device.
For more information, refer to
3. Mount the device.
For more information, refer to
Connect the failsafe alarm relay.
4.
For more information, refer to
5. Connect power and ground the device.
For more information, refer to
6. Connect the device to the network.
For more information, refer to
7. Configure the device.
For more information, refer to
Section 2.2

Unpacking the Device

When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
6
Section 6.1, "Approvals".
Section 2.2, "Unpacking the
Section 2.4, "Mounting the
Section 2.5, "Connecting the Failsafe Alarm
Section 2.6, "Connecting
Section 2.7, "Connecting the Device to the
Section 3.2, "Configuring the
Device".
Device".
Relay".
Power".
Network".
Device".
RUGGEDCOM RSG907R
Installation Guide
General Procedure