Smeg PL19K Instruction Manual page 11

User instructions
CANCELLING THE CURRENT PROGRAM
To cancel the currently selected program, press the START/STOP (5) button for a few seconds,
until the active program appears on the INFORMATION DISPLAY (8). At this point, to halt the
program in progress simultaneously press the HALF LOAD (6) button and the START/STOP (5)
button. The INFORMATION DISPLAY (8) will show the letter P followed by a dash (P-) and the
dishwasher will automatically advance to the end of cycle.
CHANGING THE PROGRAM
To change the program, press and hold down the START/STOP (5) button for a few seconds, then
select the new program as described previously in the instructions; press the START/STOP (5)
button again, holding it down for a few seconds.
DELAYED START
The start of the program can be delayed by 2, 4, 6, 8, 10, 12 o 18 hours. In this way, it is possible
to run the dishwasher when most convenient.
Turn the DELAYED START selector (2 - 13) until it is aligned with the number of hours of delay
required before the program start.
This information automatically appears on the INFORMATION DISPLAY (8) as well. Then proceed
to select the program in the manner described previously: the dishwasher will immediately perform
a pre-wash cycle, and then automatically initiate the countdown of the delayed start programmed;
the INFORMATION DISPLAY (8) will show the time remaining to the start of the program.
T "A" T "B"
YPE YPE
32