SMC Networks SMC-EZ6516TX User Manual page 7

FCC - Class B
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
EC Conformance Declaration - Class B
SMC contact for these products in Europe is:
SMC Networks Europe,
Edificio Conata II,
Calle Fructuós Gelabert 6-8, 2
08970 - Sant Joan Despí,
Barcelona, Spain.
This information technology equipment complies with the requirements of
the Council Directive 89/336/EEC on the Approximation of the laws of the
Member States relating to Electromagnetic Compatibility and 73/23/EEC
for electrical equipment used within certain voltage limits and the
Amendment Directive 93/68/EEC. For the evaluation of the compliance
with these Directives, the following standards were applied:
RFI * Limit class B according to EN 55022:1998
Emission:
* Limit class A for harmonic current emission according
to EN 61000-3-2/1995
* Limitation of voltage fluctuation and flicker in
low-voltage supply system according to EN 61000-3-3/
1995
Immunity: * Product family standard according to EN 55024:1998
* Electrostatic Discharge according to EN
61000-4-2:1995 (Contact Discharge: ±4 kV, Air
Discharge: ±8 kV)
* Radio-frequency electromagnetic field according to EN
61000-4-3: 1996 (80 - 1000MHz with 1kHz AM 80%
Modulation: 3V/m)
* Electrical fast transient/burst according to EN
61000-4-4:1995(AC/DC power supply: ±1kV, Data/
Signal lines: ±0.5kV)
* Surge immunity test according to EN
61000-4-5:1995(AC/DC Line to Line: ±1kV, AC/DC
Line to Earth: ±2kV )
C
OMPLIANCES
o , 4 a ,
iii