Opel Adam 1.0 2019 Owner's Manual page 190

188 Vehicle care
9. Install the wheel wrench ensuring
that it is securely located and
tighten each bolt in a crosswise
sequence. Tightening torque is
110 Nm.
10. Align the valve hole in the wheel
cover of the steel wheel with the
tyre valve before installing.
Install wheel bolt caps or centre
cap on alloy wheel.
11. Stow and secure the replaced
wheel, the vehicle tools 3 172 and
the adapter for the locking wheel
bolts 3 53.
12. Check the tyre pressure of the
installed tyre and the wheel bolt
torque as soon as possible.
Stowing a damaged wheel in the
load compartment
The spare wheel holder is not
designed for other tyre sizes than the
spare wheel.
A damaged wheel wider than the
spare wheel must be stowed in the
load compartment and secured with a
strap.
Vehicle tools 3 172.
Wheels with tyre size up to
195/55 R 16
1. Remove load compartment cover
and lift up load compartment floor.
Stow both behind the raised up
backrests of the rear seats.
2. Untwist wing nut and remove tool
box.
3. Position the damaged wheel to
stand upright into the tool box
spare, facing to the front.
4. Remove strap 1 from the tool box
and place the loop end of the strap
through the right side lashing eye.
5. Place the hook end of the strap
through the loop and pull it until
the strap is fastened securely to
the lashing eye.