100Base-Tx And 1000Base-T Ports; 100Base-Tx Management Port; Console Port - SMC Networks SMC TigerAccess SMC7824M/FSW Installation Manual

A T
BOUT THE IGER

100BASE-TX and 1000BASE-T Ports

The switch contains 24 100BASE-TX RJ-45 ports that operate at
10/100 Mbps, half or full duplex, and two 1000BASE-T RJ-45 ports that
operate at 10 Mbps or 100 Mbps, half or full duplex, or at 1000 Mbps, full
duplex. Because all of the RJ-45 ports support automatic MDI/MDI-X
operation, you can use straight-through cables for all network connections
to PCs or servers, or to other switches or hubs. (See "1000BASE-T Pin
Assignments" on page B-5.)
Each of these ports support auto-negotiation, so the optimum
transmission mode (half or full duplex), and data rate (10, 100 or
1000 Mbps) can be selected automatically. If a device connected to one of
these ports does not support auto-negotiation, the communication mode
of that port can be configured manually.
Each port also supports auto-negotiation of flow control, so the switch
can automatically prevent port buffers from becoming saturated.

100BASE-TX Management Port

The 10/100BASE-TX port labeled "Mgmt" provides a dedicated
management interface which is segregated from the data traffic crossing
the other ports.
This port supports auto-negotiation, so the optimum transmission mode
(half or full duplex) and data rate (10 or 100 Mbps) can be selected
automatically, if this feature is also supported by the attached device.
However, note that the interface connection parameters of this port
cannot be configured.

Console Port

The console port on the switch's front panel is an RJ-45 connection using
a male DB-9 connector that enables a connection to a terminal for
performing switch monitoring and configuration functions. The terminal
may be a PC or workstation running terminal emulation software, or a
terminal configured as a Data Terminal Equipment (DTE) connection. A
null-modem wired serial cable is supplied with the switch for connecting to
this interface.
1-4
A S
CCESS WITCH