Safety Equipment - Husqvarna 365 X-Torq Workshop Manual

Chain brake
Dismantling
1. First remove the following components:
• Chain and guide bar.
• Centrifugal clutch.
2. Push the hand guard forward so that the chain brake
is on. See fi g. 1
3. Unscrew hand guard, two bolts. Note sleeving on the
starter side. See fi g. 2.
4. Remove bolt (A) and chain guide-plate. See fi g. 1.
5. Undo the four bolts (B) and remove the chain brake
assembly cover. See fi g. 1.
!
WARNING!
Check that the chain brake is in the on
position. If it is not, the pressure spring
can fl y up causing personal injury.
6. Press down the retaining bush (C) and remove the
lever arm (D). See fi g 3.
7. Remove the pressure spring by freeing the rearward
end with a screwdriver. See fi g 4.
8. Remove the toggle joint (E) with attached brake-
strap. See fi g 4.
9. Disconnect the brake-strap from the toggle joint.
10. Take out the retaining bush (C) and spring. See fi g 3.
Inspection
Clean and inspect all components.
The brake-strap thickness must not be less than 0.8 mm
at any point. See fi g. 5.
14 – English

SAFETY EQUIPMENT

Fig. 1
Fig. 2
Fig. 3
Fig. 4
D
C
E