Advertisement
4. Connect this mount bracket to the tip
of the safety wire.
Safety wire (Accessory)
Mount bracket
5. Insert the 1st anchor bolt into the
mounting hole of the mount bracket.
Mounting hole
Note: The Panasonic logo will be direct-
ed to the ceiling board fixing screw
which
is
described in the illustration.
When inserting the mount bracket
into the ceiling, fit the bracket in the
4 mounting holes of 12 mm {1/2 inch-
es} in diameter on the ceiling.
Roof space
Insert the mount
bracket into the hole
Ceiling board
fixing screw
Direction of the
Panasonic logo
secured
on
the
6. Secure the mount bracket to the ceil-
ing board with the ceiling board fixing
screws (4 positions).
Turning the ceiling board fixing screws
clockwise provides ceiling board tighten-
ing between the bottom of the mount
bracket and ceiling board fixing bracket
resulting in mount bracket securing.
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Important: When securing this bracket
on the ceiling, make sure that the
four ceiling board fixing brackets are
open as shown in the following fig-
ure.
Double nuts (locally
procured)
Ceiling board
Important: When the ceiling board is the
plasterboard, make sure that no crack
side
was made on the ceiling board by
clamping.
7. Use double nuts (locally procured) to
secure the mount bracket after insert-
ing the 1st anchor bolt.
1st anchor bolt
Ceiling board
fixing bracket
Turn clockwise
Ceiling
board fixing
screw
7
Advertisement
