Kenmore 790.34913 Use & Care Manual page 11

Setting Surface Burner Controls
Setting the Turbo Boil Flex Twin Burner
The versatile Turbo Boil Flex Twin burner off ers a complete
range of gas surface settings from the same burner position.
At the lowest setting, only the burner's inner ring is active,
providing a smaller fl ame that is perfect for simmering. If
needed, the burner's outer ring may be added and when set
for HI will provide a gas fl ame that may be used to bring a
large pan of liquid to boil quickly.
Operating the Turbo Boil Flex Twin Burner
1. Place cooking utensil on surface burner.
2. Push the surface control knob down and turn
counterclockwise out of the OFF position (See Figure 1).
3. Release the knob and rotate to the Lite position.
4. Visually check that both the inner and outer rings for
the Twin burner are lit (See Figure 3). Once lit, turn the
control knob and continue to turn counterclockwise out
of the Lite position and adjust to the desired fl ame size.
5. When adjusting for a low or simmer type fl ame setting,
continue to rotate the control knob counterclockwise
from middle setting towards Lo (See Figure 1). Between
the middle and Lo settings, the fl ame for the outer ring
portion of the burner will turn off leaving only the inner
burner with a fl ame for simmering (See Figure 4). Make
any further fl ame adjustments as needed.
Figure 1 - Twin Burner Control
Figure 2 - Twin Burner
Figure 3 - Inner and Outer rings lit
Figure 4 - Inner ring only lit
Important notes:
• DO NOT cook with the surface control knob left in the
LITE position. (The electronic ignitor will continue to spark
if the control knob setting remains in the LITE position).
• When setting any surface control knob to the LITE
position, all electronic surface ignitors will spark at the
same time. However, only the surface burner you are
setting will ignite.
• NEVER place or straddle a cooking utensil over two
diff erent surface cooking areas at the same time. This
can cause uneven heating results.
11 11