Recommended Engine Oil - Yamaha Ego Solariz Owner's Manual

ZAUU0056
1. Oil strainer
2. Compression spring
3. O-ring
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
5. Check O ring, replace if necessary.
6. Install the engine oil strainer, com-
pression spring, engine oil drain
bolt with new O-ring, and then
tighten the drain bolt to the speci-
fied torque.
Make sure that the O-ring is properly
seated.
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 14 ft·lbf)
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
See page 9-1.
0.80 L (0.85 US qt, 0.70 Imp.qt)
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
7-12
8. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11621