2.8 Setting Belt Fixture
The printer can be attached to the waist belt with belt
fixture of optional parts.
The belt fixture is recommended to be attached with the
following directions.
How to attach it
1. Please remove the screw for the belt fixture on the
printer bottom surface.
2. Please tighten the screw for the belt fixture after
disposing it in the direction of the favorite.
Important
- If the belt fixture runs aground in the stopper, it cannot install to
it correctly.
- There are two tapped holes in the belt fixture. The hole used is
different depending on the direction of the installation.
2 Preparation to print
23