Connecting To A Vlan - Cisco UCS C Series Configuration Manual

Connecting to a VLAN

Procedure
Step 1 In the Navigation pane, click the Admin tab.
Step 2 On the Admin tab, click Network.
Step 3 In the Network pane, click the Network Settings tab.
Step 4 In the IPv4 Properties area, update the following properties:
Name
Enable IPv4 check box
Use DHCP check box
IP Address field
Subnet Mask field
Gateway field
Obtain DNS Server Addresses
from DHCP check box
Preferred DNS Server field
Alternate DNS Server field
Step 5 Click Save Changes.
Connecting to a VLAN
Before You Begin
You must be logged in as admin to connect to a VLAN.
Procedure
Step 1 In the Navigation pane, click the Admin tab.
Step 2 On the Admin tab, click Network.
Step 3 In the Network pane, click the Network Settings tab.
Step 4 In the VLAN Properties area, update the following properties:
Name
Enable VLAN check box
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.1(2)
44
Description
If checked, IPv4 is enabled.
If checked, the CIMC uses DHCP.
The IP address for the CIMC.
The subnet mask for the IP address.
The gateway for the IP address.
If checked, the CIMC retrieves the DNS server addresses from DHCP.
The IP address of the primary DNS server.
The IP address of the secondary DNS server.
Description
If checked, the CIMC is connected to a virtual LAN.
Configuring Network-Related Settings
OL-22894-01