Electrical; Adjusting The Headlight Beam; Replacing The Headlight Bulb - Yamaha YFM350R-W Supplementary Service Manual

ADJUSTING THE HEADLIGHT BEAM/

REPLACING THE HEADLIGHT BULB

5 cm
(1.97 in)
H
1
1

ELECTRICAL

ADJUSTING THE HEADLIGHT BEAM
1. Check:
M
H
a. Set the tire pressures and adjust the shock
b. Place the vehicle on a level surface, 5 m
5 m (16 ft)
c. Measure the distance "H" from the floor to
d. Place another mark on the wall, 5 cm
e. Apply the parking brake, start the engine,
f. Switch on the low beam, and then check the
L
2. Adjust:
M
a. Loosen the screws 1.
1
b. Position the headlight body up or down to
c. Tighten the screws 1.
L
EBS00124
REPLACING THE HEADLIGHT BULB
1. Remove:
– 31 –
• headlight beam (vertically)
MMM M MMM M M MMM M M MMM
absorbers to the specifications.
(16 ft) from a wall.
the center of the headlight, and then place a
mark on the wall at that height.
(1.97 in) lower than the mark made in step
(c).
and let it idle.
height of the headlight beam on the wall
while straddling the vehicle. The headlight
beam cut off line (the border between dark
and bright) should be aligned with the mark
made in step (d). Adjust the headlight beam
if it is not aligned with the mark.
LLL L LLL L L LLL L L LLL
• headlight beam (vertically)
MMM M MMM M M MMM M M MMM
adjust the headlight beam.
LLL L LLL L L LLL L L LLL
• headlight assembly 1
CHK
ADJ
M M MMM M M MMM M
L L LLL L L LLL L
M M MMM M M MMM M
L L LLL L L LLL L
MMM
LLL
MMM
LLL