Bissell CLEANVIEW REWIND PET 1820 Series User Manual page 5

Assembly
The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
1
Place handle on
vacuum base and
press down firmly.
3
Place extension wand clip on back
of unit, twist clockwise to lock in.
5
Wrap hose up and around the
hose wrap on the handle. Slide
end of hose into vacuum base.
NOTE: The powerfoot will not suction properly unless the hose is fi rmly attached.
2
Insert screws in
back of unit.
Tighten by rotating
the screw clockwise
until tightened.
4
Line up tabs on hose end to vacuum base and
twist clockwise to lock in.
6 7
Store Pet Store dusting
TurboEraser brush above hose
tool on front wrap in holder.
of handle.
www.BISSELL.ca
5