Stopping The Engine - Detroit Diesel MBE 4000 Service Manual

Hide thumbs Also See for MBE 4000:

Table of Contents

STOPPING THE ENGINE

www.rtrucks.ru

11.4 STOPPING THE ENGINE

If the engine has been running at full output or the coolant temperature has been high, allow the

engine to idle for one to two minutes without load.

Then turn off the ignition keyswitch.

If any the following occur, shut down the engine immediately.

The oil pressure swings back and forth or falls sharply.

Engine power and rpm fall, even though the accelerator pedal remains steady.

The exhaust pipe gives off heavy smoke.

The coolant and/or oil temperature climb abnormally.

Abnormal sounds suddenly occur in the engine or turbocharger.

Shutting Down After Hard Operation

After hard operation, do the following:

After hard operation, allow the engine to idle for one to two

minutes without load. Shutting down the engine without idling

may cause damage to the turbocharger.

1. If the engine has been running at full output or the coolant temperature has been high,

allow the engine to idle for one to two minutes without load.

2. Turn off the ignition switch and shut down the engine.

www.rtrucks.ru

www.rtrucks.ru

All information subject to change without notice.

www.rtrucks.ru

Table of Contents