Maintenance And Troubleshooting - NordicTrack NTEX78214.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 25 and
adjust the contrast level of the display.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 21.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter.
See EXPLODED DRAWING A on page 34. Using
a standard screwdriver, gently release the tabs on the
Top Shield (44). Slide the Top Shield upward.
Next, remove the M4 x 16mm Screw (77) from the
Access Cover (40). Then, remove the Access Cover.
Locate the Reed Switch (46). Turn the Left Crank Arm
(24) until a Pulley Magnet (30) is aligned with the Reed
Switch. Next, loosen, but do not remove, the indicated
M4 x 16mm Screw (77). Slide the Reed Switch slightly
closer to or away from the Pulley Magnet, and then
retighten the Screw.
Plug in the power adapter, and turn the Left Crank
Arm (24) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, unplug
the power adapter and reattach the parts that you
removed. Then, plug in the power adapter.
29
24
46
30
77