Checking The Oil Cooler; Installing The Oil Cooler - Yamaha MTN1000 2016 Service Manual

EAS30441

CHECKING THE OIL COOLER

1. Check:
• Oil cooler
Cracks/damage  Replace.
• Oil cooler fins
Obstruction  Clean.
Apply compressed air to the rear of the oil
cooler.
Damage  Repair or replace.
TIP
Straighten any flattened fins with a thin, flat-head
screwdriver.
2. Check:
• Oil cooler inlet hose
• Oil cooler outlet hose
Cracks/damage/wear  Replace.
EAS30442

INSTALLING THE OIL COOLER

1. Install:
• Oil cooler cover
(to the oil cooler)
Oil cooler cover bolt
9 N·m (0.9 kgf·m, 6.5 lb·ft)
2. Install:
• Oil cooler "1"
• O-ring
New
• Oil cooler bolt (upper) "2"
• Oil cooler bolt (lower) "3"
• Radiator bolt "4"
TIP
Apply lithium-soap-based grease to the O-ring.
3. Tighten:
• Oil cooler bolt (upper) "2"
Oil cooler bolt
10 N·m (1.0 kgf·m, 7.2 lb·ft)
4. Tighten:
• Oil cooler bolt (lower) "3"
Oil cooler bolt
10 N·m (1.0 kgf·m, 7.2 lb·ft)
5. Tighten:
• Radiator bolt "4"
Radiator bolt
10 N·m (1.0 kgf·m, 7.2 lb·ft)
6. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Refer to "CHANGING THE ENGINE OIL" on
page 3-26.
7. Measure:
• Engine oil pressure
Refer to "MEASURING THE ENGINE OIL
PRESSURE" on page 3-27.
6-5
OIL COOLER
2
2
4
1
3