Canon iX6500 Series Service Manual page 11

5 times ASF (cam)
sensor error
6 times Internal
temperature
error
7 times Ink absorber
full
8 times Print head
temperature rise
error
9 times EEPROM error [6800]
10 times VH monitor
error
- PE sensor cable
- Paper feed motor harness ass'y
Re-connect the cable.
(3) Strange sound at power-on:
Replace the purge drive system
unit.
[5700] (1) Cable connection:
- PE sensor cable, etc.
Re-connect the cable.
[5400] (1) Cable connection:
- Between the spur unit and the logic
board, J703 connector, etc.
Re-connect the cable.
[5B00] (1) Ink absorber condition:
[5B01] Replace the ink absorber, and reset
the ink absorber counter value in
the EEPROM.
[5200] (1) Print head condition (face surface and
mold):
If a burn mark or heat deformation
is seen on the face surface or the
mold, replace the print head.
(2) Head contact pin condition of the
carriage unit:
If the pin is bent or deformed,
replace the carriage unit.
(3) Cable connection:
- CR FFC (J500, J501, J502)
Re-connect the cable.
If any damage or breakage of the
cable is found, replace the carriage
unit.
(1) Part replacement:
[6801] Replace the logic board ass'y.
[B200] (1) Print head condition (face surface and
mold):
If a burn mark or heat deformation
is seen on the face surface or the
mold, replace the print head and
the logic board in set. (Be sure to
replace them at the same time.)
(2) Burn mark or heat deformation of the
logic board:
If a burn mark or heat deformation
is seen on the logic board, replace
7 / 52
- ASF unit
- PE sensor board
ass'y
- Logic board ass'y
- Spur unit
- Logic board ass'y
- Print head
- Absorber kit
- Print head
- Carriage unit
- Logic board ass'y
- Print head and logic
board ass'y (replace
them at the same
time)
- AC adapter
- Carriage unit