Thermador Masterpiece Series Installation Manual page 14

I N S T A L L A T I O N
Installation with Gas Cooktops
Dimension "BT" is thickness of
the backsplash. Provide 1/2"
(13mm) clearance between the vent
cutout and the backsplash. Any
backsplash with a curved radius
where it meets the counter will
require additional clearance. Thicker
backsplashes may be used by
increasing the counter and cabinet
depths.
Set the cooktop into the coutertop
opening so that the back edge of the
cooktop overlaps the leading edge of
the downdraft.
Prepare downdraft housing
1. Place the downdraft on its back on a table or lat work surface.
SUPPORT
LEGS
2. Slide upper support brackets into slide channel at top left and right
of unit.
Attach long or short support legs (depending upon cabinet height)
to bottom sides of unit with hex screws provided. Do not tighten hex
screws completely at this time.
Page 14
Downdraft cutout width:
30" (762) is 27-1/16" (687)
36" (914) is 33-1/16" (840)
BT
MIN.
1/2"
(13)
SLIDE
CHANNEL
UPPER
SUPPORT
BRACKET
HEX SCREW
1/4-20 X .500
(12.7MM)
Template
2-1/8" (54)
Cooktop cutout width
1-7/8" (48)
Optional: Electrical panel can be mounted in
a remote location.
#8-32 HEX
NUTS
Example: There is a drawer at the bottom of the cabinet, in front of the
downdraft. This may require the electrical panel to be mounted in an
adjacent cabinet. If blower discharge is down, electrical panel must be
relocated.
1. Remove (4) #8-32 hex nuts and electrical panel. 5-ft. (1.5 m) extension
cables (purchase separately) may be needed to mount electrical
panel in a remote location. Do not use more than 2 extension
cables (EXTNCE5). Do not mount with electrical panel slots facing
downward.
2. Installation of a remotely located electrical panel may be completed
after connecting the ductwork and installing the blower. Install
electrical panel according to local codes.
24-11/16" (628)
22-5/16" (567)
19-1/8" (486)
1-1/16"
(27)
Measurements in inches (mm).