Channel Selection - Audiovox GMRS1100-2CH Owner's Manual

- Press the Function (F) button so the Channel number flashes.
- Select the desired channel with the Up (10) and Down (11) Buttons;
then press the PTT button to confirm selection (automatic confirma-
tion occurs 10 seconds later). When receiving a call, the Monitor sec-
tion of the Transmit/Monitor LED (16) lights green .
- Press and hold the PTT button (4) to transmit, then speak into the
microphone clearly and slowly. The Transmit section of the Trans-
mit/Monitor LED (16) lights red .
- Release PTT Button (4) to receive.
- Communication can only be accomplished when the channel and
CTCSS tone frequency of at least two parties are the same.
- The CTCSS sub-channel number will be displayed on the LCD panel
if the tone frequency function is enabled.

Channel Selection

In order to communicate with other GMRS/FRS units, both transmitting
and receiving party must be on the same frequency.
The GMRS1100-2CH has 22 channels (frequencies) (1-22) indicated by
the large digits on the LCD display panel.
the shared GMRS/FRS channels. Channels 8-14 are FRS only channels,
while channels 15-22 are assigned GMRS only channels. If an FRS only
channel (8-14) has been selected, the F icon will be displayed on the LCD
panel; otherwise, for channels 1-7 (GMRS/FRS) and 15-22 (GMRS only)
the G icon will be displayed. Communication with Audiovox GMRS/FRS
and compatible units is possible on these 22 channels. Before transmit-
ting on the selected channel, press the Monitor (M) Button (2) to check the
activity on that channel. If there is activity on the selected channel, change
to another channel that is clear.
To change the channel:
- From GMRS/FRS standby mode, press the Function button (12) until
the channel number flashes.
- Press the Up Button (10) briefly to move to the next higher main chan-
nel number.
Channels 1 through 7 are
11
128-6297
11 of 24