Samsung AC***JXADCH Series User Manual page 17

Problem
The wired remote
control does not
operate.
The air conditioner
is not turned on or
off immediately
with the wired
remote control.
The Timed on/off
function does not
operate.
The indoor unit
display blinks
continuously.
I want to get cooler
air.
The air is not cool or
warm enough.
Check whether the
the auxiliary power switch, and then contact a service centre.
Check whether the wired remote control is set for group control. In this
case, the air conditioners connected to the wired remote control are
turned on or off sequentially. This operation takes up to 32 seconds.
Check whether you pressed the
after setting the on/off time. Set the on/off time.
Turn off and then turn on the auxiliary power switch, and then turn on
the conditioner.
Operate the air conditioner with a electric fan to save energy and
enhance the cooling efficiency.
In the Cool mode, cool air does not come out if the set temperature is
higher than the current temperature.
–
set temperature [minimum: 18°C (64°F)] is set to lower than the
current temperature.
In the Heat mode, warm air does not come out if the set temperature is
lower than the current temperature.
–
set temperature [maximum: 30°C (86°F)] is set to higher than the
current temperature.
Both cooling and heating do not operate in the Fan mode. Select the
Cool, Heat, Auto, or Dry mode.
decrease the cooling and heating efficiencies. Clean the air filter
frequently.
outdoor unit, remove them.
Install the outdoor unit in a well-ventilated place. Avoiding places
exposed to direct sunlight or close to a heating appliance.
sunlight.
If the indoor unit is installed in a place exposed to direct sunlight, pull
the curtains on the windows.
Solution
17
English