PEUGEOT 2008 Handbook page 88

Safety
ISOFIX mountings
The seats, shown below, are fitted with ISOFIX
compliant mountings:
The mountings comprise three rings for each
seat:
- two rings A, located between the vehicle's
seat backrest and cushion, indicated by a
marking,
- a ring B, located behind the seat, referred
to as the TOP TETHER, for fixing the upper
strap.
86
The TOP TETHER is used to secure the
upper strap of child seats that have one. This
arrangement reduces forward tipping of the
child seat in the event of a front impact.
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
ISOFIX child seats are fitted with two latches
which are secured on the two rings A.
Some seats also have an upper strap, which is
secured on ring B.
To secure the child seat to the TOP TETHER:
F remove and store the head restraint before
installing the child seat in this seat (refit it
once the child seat has been removed),
F run the strap of the child seat behind the top
of the seat backrest, centring it between the
holes for the head restraint rods,
F attach the hook of the upper strap to ring B,
F tighten the upper strap.
When fitting an ISOFIX child seat to the
left-hand rear position of the bench seat,
before fitting the seat, first move the
centre rear seat belt towards the middle
of the vehicle, so as to avoid interference
with the operation of the seat belt.
The incorrect installation of a child seat in
a vehicle compromises the protection of
the child in the event of an accident.
Strictly observe the fitting instructions
provided with the child seat.
For information on the possibilities for
installing ISOFIX child seats in your
vehicle, refer to the summary table.
ISOFIX child seats recommended
by PEUGEOT
PEUGEOT offers a range of ISOFIX child seats
listed and type approved for your vehicle.
Also consult the installation notes of the
child seat's manufacturer to find out how
to install and remove the seat.