General; Important; Safety Information; Alarm.com Introduction - DSC PowerSeries Neo Installation Manual

General

IMPORTANT

This installation manual shall be used in conjunction with the control panel. All the safety instructions specified
within that manual shall be observed. The control panel is referenced as the "panel" throughout this document.
This installation guide provides the basic wiring, programming and troubleshooting information. Use this guide
in conjunction with the installation manual available online from the DSC website at www.dsc.com.
The HSPA/CDMA alarm communicator is a fixed, wall-mounted unit, and shall be installed in the location spe-
cified in these instructions. The HSPA/CDMA alarm communicator module should NOT be installed inside of
the metal alarm panel casing; doing so will significantly impair cellular and RF (Z- Wave) transmissions.The
equipment enclosure must be fully assembled and closed, with all the necessary screws/tabs, and secured to a
wall before operation. Internal wiring must be routed in a manner that prevents:
Excessive strain on wire and on terminal connections,
l
Interference between power limited and non power limited wiring,
l
Loosening of terminal connections, or
l
Damage of conductor insulation.
l
WARNING: Never install this equipment during a lightning storm.

Safety Information

The installer must instruct the system user on each of the following:
Do not attempt to service this product. Opening or removing covers may expose the user to dangerous vol-
l
tages or other risks.
Any servicing shall be referred to service persons only.
l
Use authorized accessories only with this equipment.
l
Do not stay close to the equipment during device operation.
l
Do not touch the external antenna.
l

Alarm.com Introduction

The purpose of this guide is to introduce you to the Alarm.com communicator modules. The following sections
identify these modules and offer you a brief overview of their capabilities. Some capabilities and features vary
based on the Alarm.com service plan selected. Visit www.alarm.com/Dealer or contact Alarm.com for more
information.
Note: The HSPA3G module is available in the following models:
Module Model
HSPA3G 3G8080
3G8080-EU
The module 3G8080- EU contains the subassembly 3G8055 NEO and the PC- Link to the RS422 conversion
interface. The module is compatible only with NEO Alarm Control Unit models HS2128, HS2064, HS2032
and HS2016 software versions 1.1 and above.

HSPA 3G Module - 3G8080-EU

The HSPA module enables wireless reporting of all alarms and other system events from the DSC Neo control
panel using an all- digital, HSPA wireless (cellular) network. The module can be used as the primary com-
munication path for all alarm signaling, or as a backup to a telephone connection to the central monitoring sta-
- 8 -