Table of Contents
Advertisement
On
The extender is on.
Blinking
The extender is initializing.
(Power)
Off
The extender is off.
On
The Ethernet port is connected.
(Ethernet)
Off
The Ethernet port is not connected.
Button Explanation
Ports
(RE/WPS) Button:
If your Wireless router supports WPS or QSS function,
you can press the WPS or QSS button and then press the RE button to
establish a secure connection between the Wireless router and the extender.
This button is used to restore the extender's factory default
Reset Button:
settings. There are two ways to reset the extender:
Buttons
Option One:
With the extender powered on, use a pin to press the RESET
button until all the LEDs turn on momentarily, then release the button and
wait the extender to reboot to its factory default settings.
Restore the default settings from
Option Two:
&Restore" of the extender's Web-based Management page.
LED Button:
You can press the LED button to light up or turn off all the LEDs.
After the LEDs are off, the extender can still work normally.
Power Button：
You can press the Power button to turn on or off the extender.
Ethernet Port:
Five 10/100/1000Mbps RJ45 Ethernet ports used to add
wireless connectivity to an Ethernet-enabled device such as Internet TV,
DVR, Gaming console and so on. Please note that this port is not allowed to
be connected with router.
Positioning the Product
"System Tools > Backup
Appearance
Advertisement
Table of Contents
