Troubleshooting; Safety Instructions; Malfunction Causes And Remedies - Silvercrest KH 2377 Operating Instructions Manual

Troubleshooting

Troubleshooting
In this chapter you will receive important information for malfunction localization
and remedies. Observe the instructions in order to avoid danger and damage.

Safety instructions

WARNING
Observe the following safety information to avoid danger and property damage:
► Repairs to electronic devices may only be carried out by specialists who have
been trained by the manufacturer. Considerable danger to the consumer and
damage to the device can occur as a result of incorrect repairs.

Malfunction causes and remedies

The following table will help with localizing and remedying minor malfunctions:
Defect
The device will
not switch on
No sound
The CD will not
load or eject
KH 2377
Possible cause
The ignition is not switched on. Switch the ignition on by turning the key.
The fuse is defective.
The volume is set to minimum. Increase the volume.
The cables are not connected
correctly.
The sound is switched off .
A CD is already inserted into
the device.
The CD has been inserted
the wrong way up.
The CD is dirty or defective.
The temperature in the
vehicle is too high.
Condensation on the laser
lens
Solution
Replace the fuse.
Check the cable connections.
Press the MUTE button to switch
the sound back on.
Remove the CD.
Insert the CD with the inscripted
side up.
Clean the CD or insert a diff erent CD.
Allow the vehicle to air out until the
temperature has again dropped to the
operational temperature.
Switch the device off for a few hours
and then try it again.
GB
IE
35