Felker Mason Mate II Operating Instructions And Parts List Manual page 7

SAFETY FIRST!
WARNINGS
DO's and DO NOT's
WARNING:
FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO NOT
DO NOT operate this machine unless you have read and understood this operator's manual.
DO NOT operate this machine without the blade guard, or other protective guards in place.
DO NOT stand behind the blade path while the motor is running.
DO NOT leave this machine unattended while the motor is running.
DO NOT work on this machine while the motor is running.
DO NOT operate this machine when you are tired or fatigued.
DO NOT use a wet blade without adequate water supply to the blade.
DO NOT exceed maximum blade speed shown for each blade size. Excessive speed could result in blade breakage.
DO NOT use damaged equipment or blades.
DO NOT use carbide tipped blades.
DO NOT use conventional abrasive blades with water.
DO NOT touch or try to stop a moving blade with your hand.
DO NOT transport a cutting machine with the blade mounted on the machine.
DO NOT use a blade that has been dropped or damaged.
DO NOT touch a dry cutting diamond blade immediately after use. These blades require several minutes to cool after each cut.
DO NOT use damaged or worn blade flanges.
DO NOT allow other persons to be near the machine when starting or when the machine is in operation.
DO NOT operate this machine in an enclosed area unless it is properly vented.
DO NOT operate this machine in the vicinity of anything that is flammable. Sparks could cause a fire or an explosion.
DO NOT allow blade exposure from the guard to be more than 180 degrees.
DO NOT operate this machine unless you are specifically trained to do so.
DO NOT use a blade that has been over heated (Core has a bluish color).
DO NOT cock, jam, wedge or twist the blade in a cut.
DO NOT jam material into the blade.
DO NOT grind on the side of the blade.
DONOT replace the motor with any motor that does not have a special grounding connection.
DONOT lay power cords in or near the water.
DONOT operate this machine while using drugs or alcohol.
*****************
This saw was designed for certain applications only. DO NOT modify this saw or use for any application other than for
which is it was designed. If you have any questions relative to its application, DO NOT use the saw until you have written
Diamant Boart, Inc. and we have advised you.
Diamant Boart, Inc.
17400 West 119th Street
Olathe, Kansas 66061
7