Sony DCU-8000 Operation Manual page 8

e REF IN (reference signal input) connectors
(BNC type)
If you wish to synchronize this unit to an external reference
signal, input the reference signal. For an HDTV system,
input an HD tri-level sync signal, black burst signal, or
analog sync signal. For an SDTV system, input a black
burst signal or analog sync signal.
The two connectors have a loop-through configuration.
Signal input to one connector can be output from the other
connector. If you will not be using the loop-through
output, be sure to terminate the unused connector with the
supplied 75Ω terminator.
f U (signal ground) terminal
Connect to the system ground.
g - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
h REMOTE 1 to 6 connectors (D-sub 9-pin,
RS-422A) (MKS-8702)
Connect devices supporting VTR, DDR, E/SAM or P2
protocols.
The number of outputs differs depending on the number of
MKS-8702 Serial Interface Boards installed in the unit.
8
Location and Function of Parts