Table of Contents
Advertisement
12.
For convenient sighting along the cut
line, there are notches in the leading
edge of the Base Plate (103). Align the
left hand notch with your pencil line for
making 90° cuts. Align the right hand
notch with the pencil mark for making
45° bevel cuts. NOTE: The notches
are approximate only. For accurate
cuts, always use a straight edge guide
clamped to the work piece.
13.
If desired, you can use the Cutting
Guide (108, 109).
14.
Slide the Cutting Guide (108) through
the Base Plate (103) and secure in
position using the Thumb Screw (93).
15.
Align the Cutting Guide Fence (109)
with the edge of the work piece, and
use it to guide the saw during the cut.
This tool will help you make straight
cuts, and can also be used to cut
several pieces of the same width.
CAUTION: Do not hold the Cutting
Guide with one hand and the saw
with the other. Always use two hands
when operating this saw.
16.
To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean the work surface and
underside of base plate (103), then
store the tool indoors out of children's
reach.
SKU 66660
For technical questions, please call 1-800-444-3353.
Page 16
Advertisement
Table of Contents
