Complete The Installation - Siemens C) Installation Instructions Manual

Complete the Installation

English 14
• A risk of tip-over may exist if the appliance is not installed in accordance with
these instructions.
• If the range is pulled away from the wall for cleaning, service, or any other rea-
son, insure that the Anti-Tip Device is properly reengaged when the range is
pushed back against the wall. In the event of abnormal usage (such as a person
standing, sitting, or leaning on an open door), failure to take this precaution could
result in tipping of the range. Personal injury might result from spilled hot liquids or
from the range itself.
1. Adjust height of range and level by rotating the adjustable leg supports on the
bottom of the range, using 1-1/4 inch (31.75 mm) wrench. See Figure 2:
Adjusting the Leg Support.
3. Measure to locate bracket position as shown in Figure 4: Anti-tip Bracket
Location.
cabinet wall
5. Secure bracket with 2 screws (not included) that are adequate for mounting
surface. (i.e.; for wood floor use wood screws for concrete floor use concrete
anchors and screws).
1. Move range close enough to the opening to plug into the receptacle.
2. Slide range into position insuring that the left back leg slides under the anti-tip
bracket. Range will sit 3/4" (19.05 mm) away from back wall when properly
installed.
3. Carefully tip range forward to insure that the anti-tip bracket engages the
range back brace and prevents tip-over.
4. Turn on electrical power. Check range for proper operation as described in
Use and Care Manual.
drawer
wrench
adjustable leg
Figure 2: Adjusting the Leg Support
rear wall
9/16" (14.29 mm)
from rear wall to center of screw hole
anti-tippin g
device
flush against
cabinet wall
Figure 4: Anti-tip Bracket Location
Installation
floor