Blizzard B54 Operator And Parts Manual page 14

NOTE: Before cutting, make sure the two shafts
intersect by at least 7 3/4" when in working
position that is when the snowblower rests on the
ground.
3. Hold the two half-shaft side by side and locate
the "L" length between the two center-to-
center half-shaft universal joints. Mark off the
zone to be cut on both halves opposite each
half-shaft guard as shown on Figure 4
4. Cut off inner and outer guard tubes as well as
the inner and outer telescopic sections.
5. Cut the guard a second time leaving the
same distance between the end of the guard
and the end of the shaft as existed before.
To obtain the proper distance "A" shown on
Figure 5, cut the guard according to the
following table:
DISTANCE A
Male PTO
1 3/4"
6. File down tubes and remove chips.
7. Apply grease to inside of outer telescopic
section.
IMPORTANT: Work with fully guarded shafts
only!
OM 0277-A
ASSEMBLY
Female PTO
1 1/4"
Figure 5
12
Figure 4
A