Installation / Un-Installation; Wiring Connections - Soundstream VRN-DD7HB Owner's Manual

INSTALLATION / UN-INSTALLATION

Note
Before starting installation of the unit, make sure
the wiring is connected properly.
Use only the parts provided with the unit to ensure
proper installation.
The use of unauthorized parts may cause
malfunction.
Install the unit where it does not get in the driver's
way and will not injure the passenger in case
there is a sudden stop, like an emergency stop.
INSTALLATION （Figure 1）
Insert the unit into dash-board hole and fix it
If necessary, place the mount strap at the
rear of the unit and fix it with provided washer
as figure 2.
Push the unit into the Half Sleeve until you
hear a click sound
Place Trim Ring over the unit and installation
is completed as figure 3. (Some vehicle may
not need Trim Ring).
UN-INSTALLATION
Insert the supplied extraction keys into the
unit and pull the unit out with keeping the
extraction keys. (as Figure. 4)

WIRING CONNECTIONS

Make sure you have good chassis ground. A good
ground connection will eliminate most electrical
noise problems. A good chassis ground requires a
tight connection to the vehicle's metal chassis.
The area around the ground connection should be
clean, bare metal without rust, paint, plastic,
dust, or dirt for a good electrical connection.
Caution: Do not interchange the connection of the
wiring!!!
For some car models you may need to modify
wiring of the supplied power cord. Contact your
authorized car dealer before installing this unit.
Using the power connector
Cut the connector; connect the colored leads of
the power cord to the car battery as shown in the
color code table below for speaker and power
cable connections.
Figure.1
Dashboard
Figure.2
Mounting Strap
A mounting strap id often included with new
stereos. For most installations, it is not necessary
part of the installation process. However, It can be
useful to help support the stereo in yr dash; it also
helps reduce vibration. One end of mounting strap
attaches (with a screw) to the rear of the stereo.
The other end attaches
to an existing bolt or
screw behind the dash.
Just bend the shape as
n e c e s s a r y t o e n a b l e
mounting.
V-OUT1 V-OUT2 FL FR
CAM VIN RL RR
Radio
LIN RIN Sub1 Sub2
Antenna
1 FL+(White) 2 FL-(White/Black)
6 IR(Green)
7 SWC 2(White/Blue)
11 FR+(Grey) 12 FR-(Grey/Black)
5
Figure.4
Figure.3
Yellow
V-OUT1
Yellow
V-OUT2
White
RL
White
FL
Red
RR
Red
FR
Blue
Subwoofer 2
Blue
Subwoofer 1
Red
Right input
Yellow
Video input
1 2 3 4 5
White
Left input
Yellow 11 12 13 14 15
Camera
Power Connector
3 RL+(Green) 4 FR-(Green/Black)
8 SWC 1(White) 9 Camera(Brown) 10 Parking Brake(Pink)
13 RR+(Purple) 14 RR-(Purple/Black)
USB
6 7 8 9 10
16 17 18 19 20
5 ACC 12V+(Red)
15 Ground- (Black)