Table of Contents
Advertisement
32
PICTURE ID Settings
AUDIO
(RGB/DVI)
•
Only applies to certain models.
is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
REMOTE
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
CONTROL IN
monitor is identified by a Set ID. If you assign the
and Set ID can be controlled remotely.
1
Assign the Set ID to the installed monitors as shown below.
IR & Light Sensor
RS-232C cables
2
Press the red ON button on the remote control to assign the PICTURE ID.
3
Assign the Set ID to the selection of your choice.
•
A set with a different Set ID from the PICTURE ID cannot be controlled by IR signals.
NOTE
•
If PICTURE ID is set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals.
•
If you press the green OFF button for PICTURE ID, the PICTURE IDs for all monitors are turned off. If you then press
any button on the remote control, all monitors can be controlled by IR signals regardless of Set ID.
RS-232C OUT
RS-232C OUT
RS-232C OUT
RS-232C IN
RS-232C IN
RS-232C IN
PICTURE ID
ON [2]
using the remote control, only displays with matching
Advertisement
Table of Contents
